3 Easy Steps to Refill a SRA Flux Pen

0Shares

In today's post I'm going to talk about how to refill your flux pen. If you've never done it before, then it might be a little tricky and even a bit messy. But, I'm going to break it down for you into three easy steps.

First, let's start with the tools you'll need to get this done. Of course you'll need some flux refill to fill the pen. You'll also need a pair of pliers, to make it easier to remove the dispensing tip. Additionally, you might want a rag or paper towels nearby for any cleanup and to keep the flux off everything.

Tools Needed

Now let's fill a flux pen...

1. With a pair of pliers carefully remove the dispensing cap and attached felt tip.

2. Slowly refill pen body with liquid flux from refill bottle.

3. After the pen body is filled, secure the dispensing cap and tip with the pliers into the pen body.

*Note-The felt tip can be easily replaced with a new felt tip, simply by sliding the old one out, and sliding the new replacement tip in it's place.

Now that you have your flux pen refilled you are ready to get to work and finish off those pesky soldering projects you put on hold until now. Good luck and happy soldering!

For a visual reference on refilling a flux pen checkout the video below from our YouTube channel:

3 Easy Steps to Refill a SRA Flux Pen
0Shares

Was this post helpful?

Providing soldering and brazing solutions 
for more than 50 years.
cross-circle
linkedin facebook pinterest youtube rss twitter instagram facebook-blank rss-blank linkedin-blank pinterest youtube twitter instagram
Share via
Copy link
Powered by Social Snap